Load Output Settings; Streetlight Settings - Victron energy BlueSolar 100/30 Manual

5.2.2. Load output settings

The load output settings be used to drive the TX pin in the VE.Direct port, which can then be used to drive a BatteryProtect, a
relay or an other load-shedding device. For more information see chapter
The available operation modes are:
• Always off
The load output is always OFF
• BatteryLife algorithm:
This is a self adapting algorithm to maximize life of the battery. For more information see chapter
• Conventional algorithm 1:
12V system: OFF when Vbatt < 11.1V, ON when Vbatt > 13.1V
24V system: OFF when Vbatt < 22.2V, ON when Vbatt > 26.2V
48V system: OFF when Vbatt < 44.4V, ON when Vbatt > 52.4V
• Conventional algorithm 2:
12V system: OFF when Vbatt < 11.8V, ON when Vbatt > 14.0V
24V system: OFF when Vbatt < 23.6V, ON when Vbatt > 28.0V
48V system: OFF when Vbatt < 47.4V, ON when Vbatt > 56.0V
• Always on:
The load output is always ON
• User defined algorithm 1:
OFF when Vbatt < Vlow, ON when Vbatt > Vhigh.
• User defined algorithm 2:
OFF when Vbatt < Vlow or Vbatt > Vhigh and ON when Vbatt is between Vlow and Vhigh.
The "always off" and the "always on" modes will respond immediately. The other modes have a 2 minute delay before the load
output changes. This is so that the solar charger does not respond too quickly when, for example, an inrush current briefly lowers
the battery voltage below the threshold.
The load output settings also controls the streetlight algorithm. Both work together to protect the battery from being too deeply
drained. The streetlight settings are overridden should the battery voltage falls below the load disconnect voltage. When the
battery voltage increases to the load reconnect voltage, the streetlight function will resume.

5.2.3. Streetlight settings

The streetlight function enables the solar charger to automatically control night lighting. It will automatically determine when the
light should be on or off and can control the light intensity.
When the streetlight function is enabled a timer program can be created whereby Sunset, Sunrise as well as Midnight can be
used as anchor points for the timer program. These anchor points will automatically adjust depending on length of the night as
this changes with the seasons.
Page 21
MPPT solar charger manual
TX port settings [24].
???
Configuration and settings