Air Filtration - Santa Fe ULTRA Series Installation & Operation Instructions

The Santa Fe Dehumidifier is equipped with a MERV-13 (Dimensions: 1.75" x 14.00" x 17.50") filter. The filter
should be checked and replaced every three to six months. Operating the unit with a dirty filter will reduce
dehumidifier capacity and efficiency.
DO NOT operate the unit without the recommended filter. Filter non-compliance voids the product warranty.
CAUTION! CAUTION!
MAKE SURE UNIT IS OFF BEFORE CHANGING THE FILTER.
Changing the Filter
For greatest filtration and efficiency of the Santa Fe Dehumidifier, it is recommended the air filter be
replaced every three to six months with a MERV-13 filter.
Magnetic Strip
Step 1: Pull back slide latch to swing filter door open.
Fresh Air Intake
(Optional)
Side View Side View
Step 2: Remove the filter by gently pulling it straight out of the unit. Insert new filter by gently pushing it
straight into the unit. Make sure the AIR FLOW arrow on the filter is pointing into the unit.
Supply Supply
Filter
Fresh Air
Intake
(Optional)
Return
Fresh Air Fresh Air
Intake Intake
(Optional) (Optional)
Step 3: Insert filter door into tabs
and swing door closed to lock
the latch into place.
14
Santa Fe ULTRA98/ULTRA120 Installation & Operation Instructions

AIR FILTRATION

Supply Supply
Slide Latch
Return
Filter Door
Side View
Filter
Door
Tabs
Top View Top View
Side View
To Remove,
pull out straight.
Filter Filter
Return Return
Front View
Filter
Side View
To Replace,
push in straight.
Filter Filter
Return Return
Front View
Santa-Fe-Products.com | 800.533.7533
Side View