Table of Contents
Advertisement
4
Additional Cleaning Information
How to clean bare fiber ends
How to clean large area lenses and mirrors
48
The following cleaning procedures may be used with other
optical equipment:
• How to clean bare fiber ends
• How to clean large area lenses and mirrors
Bare fiber ends are often used for splices or, together with other
optical components, to create a parallel beam. The end of a fiber
can often be scratched. You make a new cleave. To do this:
Strip off the cladding.
1
Take a new soft tissue and moisten it with isopropyl alcohol.
2
Carefully clean the bare fiber with this tissue.
3
Make your cleave and immediately insert the fiber into your
4
bare fiber adapter in order to protect the surface from dirt.
Some mirrors, as those from a monochromator, are very soft
and sensitive. Therefore, never touch them and do not use
cleaning tools such as compressed air or polymer film.
Some lenses have special coatings that are sensitive to solvents,
grease, liquid and mechanical abrasion. Take extra care when
cleaning lenses with these coatings.
Lens assemblies consisting of several lenses are not normally
sealed. Therefore, use as little liquid as possible, as it can get
between the lenses and in doing so can change the properties of
projection.
Preferred Procedure
Use the following procedure on most occasions.
Blow away any dust or dirt with compressed air.
1
Procedure for Stubborn Dirt
Use this procedure when there is greasy dirt on the lens:
Agilent DFB Laser Source Module User's Guide
Advertisement
Table of Contents
