Summary of Contents for Smithco Super Star 42-000-E
Page 1
Gas Model 42-000-E and 42-001-D Diesel Model 43-100-A Super Star X-treme Gas Model 43-000-A Diesel Model 43-001-A Super Rake Gas Model 13-550-D and 13-551-D Diesel Model 17-001-E June 2006 Product Support: Hwy SS & Poplar Ave; Cameron WI 54822 1-800-891-9435 productsupport@smithco.com...
CONTENTS Introduction ............ 1-16 Introduction ..................1 Symbols ..................2-3 Safety ....................4 Warning Decal Location ..............5-7 Safe Practices .................. 8 Super Star Gas and Diesel Specifications ......... 9 Super Rake Gas and Diesel Specifications ........10 Super Star X-treme Gas and Diesel Specifications ......11 Setup ....................
All Smithco Smithco Smithco Smithco machines have a Serial Number and Model Number. Both numbers are needed when ordering Smithco parts. Refer to engine manual for placement of engine serial number. The serial number plate on the Super Rakes is located on the right side main frame.
SYMBOLS Read Electrical Power No Electrical Operator’s Power Manual Engine - Stop Engine - Start Engine - Run Temperature Water Engine Oil Light Temperature Gasoline Diesel Glow Plug - On Glow Plug - Off Glow Plug Hour Meter Hour Meter Fuse Hand Throttle Choke - Closed...
Page 5
SYMBOLS Up/Down Arrow Down/Lower Up/Raise Manual No Smoking Moving Parts Operation Step Hot Surface Pinch Point Hydraulic Fluid Lift Arm Tractor Penetration Engage Disengage Ground Speed Fast Slow Forward High Warning Danger Reverse Neutral Caution...
SAFETY SAFETY Read and understand this manual and all safety signs before operating and maintaining. Review the safety instructions and precautions annually. TAKE NOTE! THIS SAFETY ALERT SYMBOL FOUND THROUGHOUT THIS MANUAL IS USED TO CALL YOUR ATTENTION TO INSTRUCTIONS INVOLVING YOUR PERSONAL SAFETY AND THE SAFETY OF OTHERS.
SAFETY SIGN LOCATION SUPER STAR REMEMBER: If Safety Signs have been damaged, removed, become illegible or parts replaced without decals, new decals must be applied. New decals are available from your authorized distributor or factory.
Page 8
SAFETY SIGN LOCATION SUPER RAKE REMEMBER: If Safety Signs have been damaged, removed, become illegible or parts replaced without decals, new decals must be applied. New decals are available from your authorized distributor or factory.
Page 9
SAFETY SIGN LOCATION X-TREME REMEMBER: If Safety Signs have been damaged, removed, become illegible or parts replaced without decals, new decals must be applied. New decals are available from your authorized distributor or factory.
20. Use parts and materials supplied by Smithco Smithco Smithco Smithco only. Do not modify any function or part. Smithco hese machines are intended for professional maintenance on golf courses, sports turf, and any other area maintained turf and related trails, paths and lots. No guaranty as to the suitability for any task is...
SPECIFICATIONS SUPER STAR WEIGHTS AND DIMENSIONS GAS SUPER STAR DIESEL SUPER STAR Length 64" (1.7 m) 68" (1.7 m) Width 57" (1.5 m) 60" (1.5 m) Height 47" (1.2 m) 50" (1.2 m) Wheel Base 41" (1.04 m) 44" (1.1 m) Weight 950 lbs.
SPECIFICATIONS SUPER STAR X-TREME WEIGHTS AND DIMENSIONS GAS SUPER STAR X-TREME DIESEL SUPER STAR X-TREME Length 64" (1.63 m) 64" (163 cm) Width 57" (1.45 m) 57" (145 cm) Height 47" (1.19 m) 47" (119 cm) Wheel Base 41" (1.04 m) 41"...
SETUP The Bunker Rakes arrive from Smithco Smithco with some assembly required before service. Smithco Smithco Smithco 1. Set park brake. Push the brake down past center and the park brake is engaged. 2. Rear wheel mounting. Block front tire. Jack up rear of machine being careful not to damage underside of machine.
CONTROLS & INSTRUMENTS GAS SUPER RAKE INSTRUMENT PANEL Located on right fender. A. Ignition Switch: Three Position. Stop-Run-Start. B. Two Or Three Wheel Drive: Front wheel drive valve is located on front right fender. Push to engage front wheel drive and pull to dis- engage front wheel drive.
CONTROLS & INSTRUMENTS DIESEL SUPER RAKE INSTRUMENT PANEL Located on right fender. A. Ignition Switch: Four Position. Preheat-Stop-Run-Start. B. Hour Meter: THe hour meter indicates the hours of machine operation. It operates only when the ignition switch is on. THe volt meter indicates battery voltage.
CONTROLS & INSTRUMENTS SUPER STAR INSTRUMENTS LOCATED ON THE CONTROL PANEL Electric On/Off Valve Switch - Toggle switch that turns 2 Wheel to 3 Wheel Drive. For 42-117 Optional Electric Valve Kit. Oil Light - The oil light should come on when ignition is on without engine operating.
CONTROLS & INSTRUMENTS DIESEL SUPER STAR STRUMENTS LOCATED ON THE CONTROL PANEL Oil Light - The oil light should come on when ignition is on without engine operating. The oil light will light when the oil pressure is low. If oil light should come on, shut off engine immediately and find the cause.
CONTROLS & INSTRUMENTS SUPER STAR X-TREME NSTRUMENTS LOCATED ON THE CONTROL PANEL Oil Light - The oil light should come on when ignition is on without engine operating. The oil light will light when the oil pressure is low. If oil light should come on, shut off engine immediately and find the cause.
CONTROLS & INSTRUMENTS DIESEL X-TREME INSTRUMENTS LOCATED ON THE CONTROL PANEL Oil Light - The oil light should come on when ignition is on without engine operating. The oil light will light when the oil pressure is low. If oil light should come on, shut off engine immedi- ately and find the cause.
OPERATION AND DAILY CHECK LIST STARTING ENGINE Before operating this machine, become familiar with all controls and functions of these units. Also complete all maintenance requirements and read all safety warnings. By knowing the machine thoroughly, how it operates and by doing the prescribed maintenance steps, you can expect relatively trouble-free operation for years to come.
DAILY CHECKLIST Use all procedures and parts prescribed by the manufacturer's. Read the engine manual before operation. The suggested maintenance checklist is not offered as a replacement for the manufacturer’s but as a supple- ment. You must adhere to guidelines established by manufacturer for warranty coverage. In adverse conditions such as dirt, mud or extreme temperatures, maintenance should be more frequent.
HOW TO RAKE A SAND TRAP HOW TO RAKE A SAND TRAP View bunker to determine the most efficient pattern to follow so that rake pattern and configuration of bunker will flow in same general direction and look attractive. Enter bunker at its lowest point. Perhaps drain area or another point where “lip” of the trap is minimal. Operate at 2-4 m.p.h.
BATTERY BATTERY Batteries normally produce explosive gases which can cause personal injury. Do not allow flames, sparks or any ignited object to come near the battery. When charging or working near battery, always shield your eyes and always provide proper ventilation. Battery cable should be disconnected before using "Fast Charge".
Gas Super Rake 13-550-D/13-551-D Diesel Super Rake 17-001-E Super Star 42-000-E/42-001-D Diesel Super Star 43-100-A Super Star X-Treme 43-000-A Diesel Super Star X-treme 43-001-A...
Batteries. Wheels and tires. A copy of the warranty for the above items is furnished if necessary with each SMITHCO product. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitations of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
Need help?
Do you have a question about the Super Star 42-000-E and is the answer not in the manual?
Questions and answers