Switching Off; At The End Of The Service; Interlock; Electrical Models - Electrolux Frytop N9E Installation And Operating Manual

F.2.2

Switching off

To turn off the main burner
• Turn knob "A" to position to turn off the main burner;
• To turn off the pilot burner turn knob "A" to
F.2.3

At the end of the service

• Turn the knob "A" to position;
• Close the gas shut-off tap.
F.3

Interlock

The valve features a thermal re-light locking device enabled
until the thermocouple is hot.
Such device, called interlock, keeps engaged for about 40
seconds in case of accidental pilot flame shut off, hence
allowing accumulated gas to flow out through the chimney
prior to light any spark again.
Forcing the interlock leads to a valve damage which is not
covered by the original manufacturer warranty.
F.4

Electrical models

The control panel is composed of the following items:
A "Thermostat knob"
B "Indicator of heating element"
C "Indicator on/off"
C
B
G MACHINE CLEANING AND MAINTENANCE
WARNING
Refer to "Safety Information".
G.1

Ordinary maintenance

G.1.1

informations for maintenance

Routine maintenance operations can be carried out by non-
specialised personnel, carefully following the instructions
given below.
CAUTION
Before carrying out any cleaning opera-
tion, disconnect the appliance from the
power supply.
Do not use ice or water to quickly cool the cooking plate.
Do not use ice or water for cleaning when the cooking plate is
hot as this would cause the cooking plate to permanently
deform and compromise appliance operation
NOTE!
The manufacturer declines any liability for opera-
tions carried out on the machine without following
these instructions.
20
position.
A
F.4.1

Switching on

• Turn on the main switch located ahead of the appliance.
• Turn thermostat knob "A"" to the required temperature.
Lighting up of green indicator "C" signals that the power is
on.
Lighting up of indicator "B" signals that the heating elements
are on.
• The indicator goes off when the set temperature is reached.
F.4.2 Switching off
• Turn the control knob "A" to "0" position.
IMPORTANT
Pay attention to the selection and use of cleaning
products in order to maintain proper appliance
performance and safeness.
G.1.2

Cleaning the appliance and accessories

Before using the appliance, clean all the internal parts and
accessories with lukewarm water and neutral soap or products
that are over 90% biodegradable (in order to reduce the
emission of pollutants into the environment), then rinse and dry
thoroughly.
IMPORTANT
Do not use solvent-based detergents (e.g. trichloro-
ethylene) or abrasive powders for cleaning.
G.1.3

External parts

SATIN-FINISH STEEL SURFACES (daily)
• Clean all steel surfaces: dirt is easily removed when it has
just formed.
• Remove grime, fat and other cooking residuals from steel
surfaces when cool using soapy water, with or without
detergent, and a cloth or sponge.
Dry the surfaces thoroughly after cleaning.
• In case of encrusted grime, fat or food residuals, go over
with a cloth or sponge, wipe in the direction of the satin
finish and rinse often: