Electrical Connection; Machine Space Limits; A.10 Positioning - Electrolux Frytop N9E Installation And Operating Manual

A.8

Electrical connection

Before connecting, make sure the mains voltage and frequency match those indicated on
the appliance data plate.
• Work on the electrical systems must only be carried out by specialised personnel.
• Connection to the power supply must be carried out in compliance with the regulations
and provisions in force in the country of use; arrange a suitable high-sensitivity manual-
reset differential omnipolar thermal-magnetic switch with contact gap enabling complete
disconnection in category III overvoltage conditions.
• If the power cable is damaged, it must be replaced by the Customer Care Service or in
any case by specialised personnel, in order to prevent any risk.
• Verify that a safety circuit breaker is installed between the power cable of the appliance
and the mains electric line. The contact opening max. distance and leakage current
must comply with the local safety regulations.
• Be sure to power the equipment with systems that are protected against overvoltage;
the manufacturer declines all responsibility for effects due to anomalies induced by the
electrical supply system.
A.9

Machine space limits

• A suitable space must be left around the appliance (for operations, maintenance, etc.).
• This space must be increased in case of use and/or transfer of other equipment and/or
means or if exit routes are necessary inside the workplace.

A.10 Positioning

• Install the appliance, taking all the safety precautions required for this type of operation,
also respecting the relevant fire-prevention measures.
• Handle the appliance with care in order to avoid damage or danger to people. Use a
pallet for handling and positioning.
• The installation diagram gives the appliance overall dimensions and the position of
connections (gas, electricity, water). Check that they are available and ready for making
all the necessary connections.
• Prevent the areas where the machine is installed to be polluted with corrosive
substances (chlorine, etc.). In case such prevention cannot be guaranteed, the entire
stainless steel surface has to be coated by a paraffin protective film spread by using a
rag soaked with paraffin. The manufacturer declines any liability for corrosive effects
due to external causes.
• The appliance can be installed separately or combined only with other appliances of the
same range.
• The appliances are not suitable for recess-mounting. Leave a space of at least 150 mm
between the appliance and side walls and 100 mm from the rear wall, or in any case an
adequate space to enable subsequent servicing or maintenance operations.
• Suitably insulate surfaces that are at distances less than that indicated.
• Maintain a distance of at least 200 mm between the appliance and any combustible
walls. Do not store or use flammable materials and liquids near the appliance.
• Check and, if necessary, level the appliance after positioning. Incorrect levelling can
cause appliance malfunctioning.
• Wear protective gloves and unpack the machine, carrying out the following operations:
– cut the straps and remove the protective film, taking care not to scratch the surface if
scissors or blades are used;
– remove the cardboard top, the polystyrene corners and the vertical protection pieces;
10