How To Use Socket Connection - Owon 4-CH VDS6000 Series User Manual

Trigger Type
Trigger Mode
Trigger Coupling
Trigger Slope
Trigger Level
Turn On / Off Channels
Vertical Coupling
Zero Point Position
Vertical Scale
Horizontal Level
Horizontal Sale
Run/Stop Status
Acquisition Mode
Display Format
Run/Stop
To start or stop sampling on input signals.
Single Trigger
To set trigger mode in "Single", under this trigger mode, when set condition met, the device will capture
the input signal once, then stop signal capturing.
Ctrl + Enter AutoSet
F5 Run/Stop
xii. how to use socket connection
when the device communicates with PC by direct network cable
For the device, its default IP address / port goes in 192.168.1.172 / 8866.
When the device communicates with PC by direct network cable, the first 3 segments from the default IP
address of PC should read the same as those from the device, giving an example, both of 2 parties read
192.168.1.xxx (the last segment "xxx" could be different).
Note: The IP address of the device could not be modified before successfully communicating with PC.
i) to check target PC's network setting
giving an example, here we set IP address in 192.168.1.71
Trigger
Edge, or Video, as per the input signal
Auto
DC
Rise
mid-point setting
Channel
turn on the channel with signal input
DC
been adjusted to the proper position
been adjusted to the proper division
middle
been adjusted to the proper division
Sampling
Run
current
Display
YT
Keyboard Shortcuts
４０