Table of Contents
Advertisement
Warnings
SKIN INJECTION HAZARD
Spray from the applicator, hose leaks, or ruptured components can inject fluid into your body and cause
extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can
also cause serious injury.
•
Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgi-
cal treatment.
•
Do not point the applicator at anyone or at any part of the body.
•
Do not put hand or fingers over the front of the applicator.
•
Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
•
follow the Pressure Relief Procedure whenever you are instructed to: relieve pressure; stop dispens-
ing; clean, check, or service the equipment; or install or clean a nozzle.
•
Tighten all the fluid connections before operating the equipment.
•
Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
•
Always wear eye protection and protective clothing when installing, operating, or servicing this dis-
pensing equipment.
•
Do not remove or modify any part of the applicator; this can cause a malfunction and result in seri-
ous bodily injury.
•
Use extreme caution when cleaning or changing nozzles. If the nozzle clogs while applying material,
Always follow the Pressure Relief Procedure, then remove the nozzle to clean it.
•
Never wipe off build-up around the nozzle or inlet cap until pressure is fully relieved.
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
•
Ground the equipment and the object being dispensed. See Grounding.
•
Ground the equipment and the object being sprayed, and all other electrically conductive objects in
the dispense area. Proper grounding dissipates static electricity generated in the equipment. See
Grounding.
•
Do not use this equipment with flammable liquids.
•
Keep the dispense area free of debris, including solvent, rags, and gasoline.
•
If there is any static sparking or you feel an electric shock while using the equipment, stop
dispensing immediately. Do not use the equipment until you have identified and corrected the
problem.
•
Be sure all electrical work is performed by a qualified electrician only.
•
Have any checks, installation, or service to electrical equipment performed by a qualified electrician
only.
•
Be sure all electrical equipment is installed and operated in compliance with applicable codes.
•
Be sure power is disconnected when servicing and repairing equipment.
•
Before operating the equipment, extinguish all open flames or pilot lights in the dispense area.
•
Do not smoke in the dispensing area.
•
Keep liquids away from the electrical components.
•
Disconnect electrical power at the main switch before servicing the equipment.
4
WARNING
309403R
- Quick Links:
- Parts
Hide quick links:
Advertisement
Table of Contents
