Table of Contents
Advertisement
Cleanup
Cleanup
Cleaning the sprayer is required after each
use to remove any disinfectants and residues
from the sprayer. It will also help ensure a
trouble free start up the next time the sprayer
is used.
Use only water for cleaning.
Clean in a well-ventilated area. Keep a
good supply of fresh air moving through
the area.
NOTICE
Disinfectant left in sprayer will damage the
sprayer. To avoid damage, always
completely flush with warm soapy water
after every use. See Cleanup, page 20. Do
not store sprayer with disinfectant in it.
1.
Perform Pressure Relief Procedure,
page 12.
2.
Pour any remaining disinfectant out of
the Hopper into waste bucket.
3.
Remove Spray Tip Guard and Spray Tip.
For additional information, see Clean
the Gun, page 21.
20
4.
Remove Drain Tube from Hopper, wipe
excess disinfectant from outside of Drain
Tube and inside of Hopper.
5.
Place Drain Tube in waste bucket. For
disinfectants with alcohol active
ingredients, ground the bucket
according to Grounding, page 10.
ti27268a
6.
Pour warm soapy water into the Hopper.
7.
Turn ON/OFF Switch to ON position.
8.
Rotate Pressure Control Knob clockwise
until the pump turns on.
ti272
265a
3A7653D
Advertisement
Table of Contents
