Table of Contents
Advertisement
Grounding
Grounding
The equipment must be grounded to
reduce the risk of static sparking and
electric shock. An electric or static spark
can cause fumes to ignite or explode. An
improper ground can cause electric shock.
A good ground provides an escape wire for
the electric current.
This sprayer is equipped with a Power Cord
that has a ground wire and an appropriate
grounding plug.
The plug must be plugged into an outlet that
is properly installed and grounded in
accordance with all local codes and
ordinances.
Do not modify the plug provided; if it does not
fit the outlet, have the proper outlet installed
by a qualified electrician.
Power Requirements
•
100-120V units require 100-120 VAC,
50/60 Hz, 8A, 1 phase.
•
230V units require 220-240 VAC, 50/60
Hz, 5A.
Extension Cords
Use an extension cord with an undamaged
ground contact. If an extension cord is
necessary, use a 3-wire, 12 AWG (2.5mm
minimum.
NOTE: Smaller gauge or longer extension
cords may reduce sprayer performance.
Pails
For disinfectants with alcohol active
ingredients: Follow local code. Use only
conductive metal pails. Ground the metal pail
by either placing it on a grounded surface, or
by attaching a ground wire.
10
Grounded surface method: Place pail on a
grounded surface such as concrete. Do not
place pail on a non-conductive surface such
as paper or cardboard which interrupts
grounding continuity.
Ground wire method: Connect a ground
wire to the pail. Clamp one end to the pail and
the other end to a true earth ground such as
a water pipe.
To maintain ground continuity when
sprayer is flushed or pressure is relieved:
Hold metal part of Spray Gun firmly to the side
of a grounded metal pail then trigger the
Spray Gun.
2
)
ti24584a
3A7653D
Advertisement
Table of Contents
