Option 7 Remote Setpoint: Modbus Header Temp Sensor & 4-20Ma Setpoint Drive - Watts Aerco Benchmark BMK750 Operation And Service Manual
With edge i controller
Hide thumbs
Also See for Aerco Benchmark BMK750:
- Operation and service manual (157 pages) ,
- Installation and start-up manual (62 pages) ,
- Design manual (12 pages)
Table of Contents
Advertisement
Benchmark with Edge [I]: Operation-Maintenance Manual
SECTION 7 – BOILER SEQUENCING TECHNOLOGY
Option 7 Remote Setpoint: Modbus Header Temp Sensor & 4-20ma
7.3.7
Setpoint Drive
OPTION 7 Instructions: Remote Setpoint, Modbus Header Temp Sensor & 4-20ma Setpoint
Drive
NOTE:
Both Header Temp Sensor and 4-20ma Direct Drive must be wired. See the Edge [i]
Controller Manual (OMM-0141, GF-213-B) for more information.
OPTION 7 Step 1:
MODBUS
1. Connect the Modbus Transmitter terminal Pin B to the RS485+ terminal, and Pin A to the
RS485- terminal on the I/O Board of any Boiler unit, using shielded pair 18 - 22 AWG cable.
2. Connect the shield to any SHLD terminal on the I/O Board.
3. Connect the Header Temp Sensor to pins 2 and 3 of the Modbus Transmitter units using
Shielded pair 18 - 22 AWG cable.
4. On the Modbus Transmitter, install a jumper wire between pins 1 and 2.
NOTES:
•
Polarity must be observed for the RS485 connections.
•
Connect the shield to any SHLD terminal on the I/O Board.
•
The Header Temp Sensor must be installed between 2 and 10 feet (0.61 and 3.1m)
downstream of the last boiler in the plant's supply water header.
•
There is no polarity to be observed. The ground for the shield is at the power supply
ground. The sensor end of the shield must be left free and ungrounded.
HEADER TEMP SENSOR
OPTION 7 Step 2: DIRECT WIRED 0-20mA or 4-20mA WIRING – BST MANAGER
1. Connect the 4-20mA or 0-20mA terminals from the Direct Drive source to the Ain+ and Ain-
terminals on the BST Manager.
2. Connect the shield to any SHLD terminal on the I/O Board.
NOTES:
•
Shielded pair 18 - 22 AWG cable is recommended for this connection. Polarity must be
observed.
•
The ground for the shield is at the driver signal source.
OMM-0145_D • GF-218 •
11/2/2020
HEADER TEMP SENSOR WIRING – ANY BOILER
MODBUS TRANSMITTER
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
I/O BOARD
I/O BOARD
Page 125 of 213
Advertisement
Table of Contents
