Care And Maintenance - Hilti BX 3-ME Original Operating Instructions

Hide thumbs Also See for BX 3-ME:
Table of Contents

Advertisement

Available languages

Available languages

2. Slide the nail downwards out of the magazine.
3. Hold the nail pusher securely and press the nail pusher release button.
4. Guide the nail pusher back to its original position.
6.5.2
Removing a nail when in single-fastener mode
▶ To remove a nail that has been inserted into the fastener guide, proceed in the same way as for removing
a jammed nail (see → page 12).
6.6
Jammed nails
Individual nails may get stuck in the fastener guide. You can remove jammed nails from the fastener guide
with the aid of the X-NP drift punch set. Accessories are available from your Hilti Center or can be ordered
online at www.hilti.com.
WARNING
There is a risk of injury and damage to the fastening tool. Use of unsuitable items instead of the
recommended genuine Hilti accessories may result in injury or damage to the fastening tool.
▶ To release a jammed nail, use only the recommended drift punch set.
CAUTION
Risk of injury by flying parts! Triggering the tool (attempting to drive a fastener) when foreign objects are
present in the area around the fastener guide, or when a fastener is jammed in the fastener guide, may lead
to injury caused by flying objects or fragments.
▶ Never attempt to remedy tool malfunctions by continuing to trigger the tool.
6.6.1
Releasing a jammed nail
1. Remove the fastener guide. → page 9
2. Fit the fastener guide into the supporting sleeve from the drift punch set.
3. Use the drift punch and a hammer to tap the jammed nail out of the fastener guide.
4. Insert the fastener guide. → page 9
7

Care and maintenance

7.1
Care and maintenance of cordless tools
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
Carefully remove stubborn dirt.
Clean the air vents carefully with a dry brush.
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the Li­ion batteries
Keep the battery free from oil and grease.
Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Avoid ingress of moisture.
Maintenance
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
12
English
Printed: 19.07.2018 | Doc-Nr: PUB / 5377482 / 000 / 02
2184329
*2184329*

Advertisement

Table of Contents
loading

Table of Contents