Maintenance. 1.41 - Hayter MT313 Operator's Manual

1.41
MAINTENANCE
WARNING : PREVENT ACCIDENTS - When carrying out maintenance procedures it is essential that:
- The engine is switched off and the ignition key removed.
- The parking brake is applied.
- There is no pressure in the hydraulic system.
- The cutterheads are fully down on the ground.
- The safety precautions in this manual have been read and understood.
IMPORTANT: PREVENT DAMAGE: Regular maintenance is essential for the continued safe
operation of the machine. Correct servicing will prolong the working life of the machine and
safeguard the "Hayter Warranty". Always fit genuine 'Hayter service parts' as these are
accurately matched to the required duty.
Dirt and contamination are the enemies of any hydraulic system. When carrying out maintenance
procedures on the hydraulic system always ensure that the work area and the components are
thoroughly clean before, during and after refitting. Ensure that all open hydraulic lines and ports, etc. are
plugged during maintenance procedures.
The recommended service intervals are based on normal operating conditions. Severe or unusual
conditions will necessitate shorter service intervals.
ALWAYS grease pivot points immediately after pressure washing or steam cleaning, refer - EVERY 50
HOURS, GREASE PIVOT POINTS.
WARNING: PREVENT ACCIDENTS - The engine, transmission oil and hydraulic systems will be
hot after machine use. Allow the systems to cool before working on the machine, particularly
before working on the engine or when changing oil or oil filters.
MAINTENANCE
1.41
995920KG200105