Table of Contents
Advertisement
1.34
CUTTERHEAD POSITION CONTROL
The cutterheads may be raised or lowered using the single lift control lever.
Note: Machines supplied with independent lift control have three control
levels (one for each cutterhead).
To lower the cutterheads, push the lift control lever(s) forwards
until locked in position 1. If the cutterhead drive switch is in the 'ON' posi-
tion, the cylinder drive will engage when the cutterheads are approximately
300mm above ground level.
IMPORTANT: PREVENT DAMAGE - The lift control lever(s) must be
locked in position 1 whilst mowing. NEVER mow with the lift control
lever(s) in position 2 (neutral).
To raise the cutterheads, pull the lift control lever(s) backwards and hold in
position 3. If the cutterhead drive switch is in the 'ON' position the cylin-
der drive will disengage when the cutterheads are approximately 300mm
above ground level. Release the lift control lever(s) when the cutterheads are
at the required height. The control lever(s) will automatically return to posi-
tion 2 (neutral).
CUTTERHEAD DRIVE ENGAGEMENT
The cutterhead drive can be engaged only when the operator is seated
correctly, refer - OPERATOR PRESENCE CONTROLS.
Release the cutterhead latches. Operate the cutterhead position controls to
the down / float position and lower all cutterheads to the ground ready for
mowing.
Forward rotation cutterhead drive engagement : Operate the cutterhead
drive switch to the 'Forward' position.
Reverse rotation cutterhead drive engagement : Operate the cutterhead
drive switch to the 'Reverse' position.
To disengage all cutterhead drives : Operate the cutterhead drive switch to
the 'Off' position.
WARNING : PREVENT ACCIDENTS - Refer OPERATOR
PRESENCE CONTROLS for additional information.
OPERATING THE MOWER
1.34
Single Lift.
Independent Lift
1. Down / float.
2. Neutral.
3. Raise.
4. Left hand cutterhead
5. Centre cutterhead.
6. Right hand cutterhead
1.
2.
3.
1. Forward.
2. Off.
3. Reverse.
995920KG200105
Advertisement
Table of Contents
