Table of Contents
Advertisement
About this task
The figure indicates the location of the I/O board and provides a visual representation of the installation procedure.
Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board with the screw holes on the palm-rest and keyboard assembly.
3. Replace the two screws (M2x2) that secure the I/O board to the palm-rest and keyboard assembly.
4. Connect the fingerprint reader cable to the I/O board and close the latch to secure the cable.
5. Connect the I/O-board cable to the I/O board and close the latch to secure the cable.
6. Adhere the tape that secures the I/O-board cable to the I/O board.
Next steps
1. Install the
display
assembly.
2. Install the
coin-cell
battery.
3. Install the
base
cover.
4. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
memory
modules.
5. Remove the
M.2 2230 solid-state drive
6. Remove the
M.2 2230 solid-state drive
7. Remove the
wireless
card.
50
Removing and installing components
After working inside your
computer.
Before working inside your
or the
M.2 2280 solid-state drive
or the
M.2 2280 solid-state drive
computer.
from M.2 slot one.
from M.2 slot two.
Advertisement
Table of Contents
