Steps
1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (following the numeral markings on the heat sink, from 1 to 4), tighten the four captive screws that secure the heat
sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
37