Table of Contents
Advertisement
About this task
The figure indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.
Steps
1. Adhere the coin-cell battery to the coin-cell battery slot on the palm-rest and keyboard assembly.
2. Route the coin-cell battery cable as illustrated and connect it to the I/O board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
NOTE:
The heat sink type in your computer varies depending on the configuration ordered.
1. Follow the procedure in
2. Remove the
base
cover.
About this task
The figure indicates the location of the heat sink and provides a visual representation of the removal procedure.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
35
Advertisement
Table of Contents
