Gas Connection; Connect To The Electricity Supply - Belling GTG 60 Series User Manual

Gas Connection

• This appliance must be installed and connected in accordance with installation regulations
in force in the country in which the appliance is to be used.
• This appliance is supplied to run on LPG and natural gas. Conversion for use on LPG and
natural gases must only be undertaken by a qualified person.
• The gas inlet is at the rear RH side of the hob. The hob should be connected to the gas
supply by rigid pipework as per the regulations in force.

Connect to the electricity supply

• This appliance must be earthed.
• This appliance is designed to be connected to a 220-240V, 50Hz-60Hz AC electricity supply.
• The wires in the mains lead are coloured in accordance with the following code;
Green/yellow = Earth
Blue = Neutral
Brown = Live
• The wire which is coloured green and yellow must be connected to the terminal which is marked
with the letter E or by the earth symbol.
The flexible mains lead is supplied connected to a BS 1363 fused plug, the plug is fitted with the correct
fuse. Replace only with a fuse of the same rating and type.
The plug and socket must be accessible after installation. Should the mains lead of the appliance ever
require replacing, we recommend that this is carried out by a qualified electrician who will replace it with
a lead of the same size and temperature rating.
Important: - Ensure that you route all mains and electrical cables and flexible tubing well clear of any
adjacent heat source.
Under no circumstances should the mains electric cable be allowed to come into contact with hot oven
flues or similar surfaces and keep well clear of any moving parts that may be in the vicinity of the
installation, such as cooling fans on adjacent appliances.
18