Table of Contents
Advertisement
DTC
Help Message
242
AMBIENT TEMPERATURE SENSOR – OUT OF
RANGE HIGH
253
DRIVE PREVENTED – CHARGER CONNECTED None
254
DRIVE & LIFT UP PREVENTED – CHARGER
CONNECTED
255
PLATFORM OVERLOADED
256
DRIVE PREVENTED – POTHOLE NOT
ENGAGED
31215087
SECTION 6 - GENERAL SPECIFICATIONS AND MAINTENANCE
Flash
Alarm
Code
PF: Continuous
2_4
• Drive and Lift Restrictions
2_5
• DriveState = PREVENTED
• DriveState = PREVENTED
None
2_5
• LiftUpState = PREVENTED
PF: 5000ms ON/
2000ms OFF
2_5
• Drive and Lift Restrictions
GND: 5000ms
ON/2000ms OFF
PF: 500ms On/
500ms Off
2_5
• DriveState = PREVENTED
GND: 500ms On/
500ms Off
Action
• The temperature as communicated by the temperature/tilt sensor is
greater than 185° F (85° C).
• Driving is not possible since the vehicle is charging.
• Driving and Lifting are not possible since the vehicle is charging and
it is configured to prevent all motion.
• While the Load Sensing System is enabled, the Platform Load mea-
sured by the Load Sensing System is excessive. Functions from Plat-
form Control Station are prevented, and functions from Ground
Control may be prevented, depending on machine configuration
(Markets other than Japan).
• For the Japanese Market, only Lift Up is prevented and Drive (at
creep speed) is allowed in the stowed position .
• Refer to LSS functionality for Lift and Drive restrictions.
• While elevated, driving is not possible since the control system
detected that the pot-hole protection mechanism failed to deploy.
Clear the obstacle blocking the pot-hole protection mechanism,
repair the mechanical problem, re-adjust the pot-hole limit
switches, or repair the wiring to correct the problem.
• Alternately, there may be difficulty with the Elevation Angle Sensor
that causes the Control System to improperly believe the platform is
elevated.
Trigger
6-25
Advertisement
Table of Contents
