SECTION 6 - GENERAL SPECIFICATIONS AND MAINTENANCE
DTC
Help Message
001
EVERYTHING OK
002
GROUND MODE OK
003
ALARM SOUNDING – TILTED & ABOVE ELE-
VATION
004
DRIVING AT CUTBACK – ABOVE ELEVATION
005
DRIVE & LIFT UP PREVENTED TILTED & ELE-
VATED
006
LIFT UP PREVENTED – MAX HEIGHT ZONE A None
007
DRIVING AT CUTBACK – POTHOLE STILL
ENGAGED
6-22
Flash
Alarm
Code
None
None
· No Motion restrictions
None
None
· No Motion restrictions
PF: Continuous
None
· No Motion restrictions
None
None
· DriveState = CREEP
• DriveState = PREVENTED
PF: Continuous
None
• LiftUpState = PREVENTED
None
• LiftUpState = PREVENTED
None
None
• DriveState = CREEP
Action
• Platform Mode and no Faults are active.
• Ground Mode and no Faults are active.
• Platform is elevated and chassis is not level
• Platform is elevated and the machine is in the drive mode of opera-
tion
• Driving and lift up are not possible since the platform is elevated and
the chassis is not level.
• The vehicle has reached the maximum height allowed by the Indoor/
Outdoor selection and further lift up motion is not possible.
• While stowed, drive speed is reduced (due to lower ground clear-
ance) since the control system detected that the pot-hole protection
mechanism is deployed (failed to retract).
• Clear the obstacle blocking the pot-hole protection mechanism,
repair the mechanical problem, re-adjust the pot-hole limit
switches, or repair the wiring to correct the problem.
• Alternately, there may be difficulty with the Elevation Angle Sensor
that causes the Control System to improperly believe the platform is
stowed.
Trigger
31215087