Teeter ComforTrak Series Assembly Instructions Manual page 9

Assemble A-Frame Base & Stretch Max Handles
FIGURE 4
RIGHT
1
2
FRONT
1 - Spreader Arms 2 - Crossbar
FIGURE 5
FIGURE 6
FIGURE 7
LOCKED
LEFT
REAR
FIGURE 4a
UNLOCKED
FIGURE 5a
FIGURE 6a
FIGURE 8
STEP 1
• Follow these instructions if you have an EP-860, EP-960,
or EP-970 model.
• On a level surface, position the A-Frame so that it is standing upright
and the Stability Feet are on the ground.
• Gently push down on the Spreader Arms to ensure they are fully open
and in the "locked" position (Figure 4).
• Look for temporary circular assembly assistance labels on the
A-Frame. RIGHT, LEFT, FRONT, and REAR indicate your position while
using the equipment, not facing it. These labels can be removed easily
upon completion of assembly.
• Locate the Handle Assembly Hardware Kit (HK1008).
• Determine the left or right handles, marked with an embossed L / R
on the inside of the black plastic part of each handle.
• Position the lower handle portion of the corresponding handle
(left / right) at the rear junction of the A-frame leg and Spreader
Arm (Figure 5 & 5a). The Lower Handle Bolt with Spacer has been
assembled loosely so that you will be able to seat the U-shaped
portion of the lower handle over the Spacer in between the
Spreader Arm and the A-frame leg. Do not tighten the bolt yet.
• Keeping the lower handle portion seated onto the Spacer, align the
upper handle portion's black plastic part over the outside edge of the
Hinge Plate on the A-Frame (Figure 6 & 6a).
• Insert and loosely hand-tighten three of the Allen Head Screws
through the Hinge Plate into the handle (Figure 7).
• Now tighten the Lower Handle Bolt using the Allen Wrench and
Open Wrench provided, ensuring that it is fully secured but not
over-tightened (Figure 8).
• Finally, tighten the Allen Head Screws for the upper handle using
the Allen Wrench provided.
• Repeat these steps on the other handle.
For EP-860, EP-960, & EP-970 Models
7