Teeter ComforTrak Series Assembly Instructions Manual page 10

For All Models
NOTE: Some models come with Traction Handles pre-assembled to
the Roller Hinges. However, the assembly instructions detailed below
still apply.
• Familiarize yourself with the 3-Hole Roller Hinge and Cam Lock
terms (Figure 9).
!
NEVER disassemble the Roller Hinge Pivot Pin.
• For ease of assembly, rest the Table Bed against the Crossbar
(Figure 10) at the front of the A-Frame.
• On one side of the Table Bed, lift and hold the Cam Lock up all
the way to unlock (Figure 11).
• In your other hand, hold one Roller Hinge near the Pivot Pin.
With the Pivot Pin facing out (away from the Table Bed), slide the
bottom of the Roller Hinge between the Cam Lock and
TIP: Make sure that the Cam Lock is completely open when inserting
the Roller Hinge, otherwise assembly will be more difficult.
• Engage one of the holes in the Roller Hinge over the Bracket Pin.
Figure 13 shows the Roller Hinge installed correctly, with the
Bracket Pin engaged in Setting C.
NOTE: Refer to the Owner's Manual for an explanation of the hole
settings. If you are unsure, use Setting C to start.
• Push down on the Cam Lock (Figure 12) to lock it and secure the
Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the
same hole setting on both sides.
8
Assemble Roller Hinges to Table Bed
WARNING
The EP-560 is shown here. Your actual model may vary.
STEP 2
FIGURE 9
Pivot Pin
FIGURE 10
the Bracket.
FIGURE 11
FIGURE 13
UNLOCKED
Bracket Pin Bracket
FIGURE 12
UNLOCK
C
B
A
LOCKED
Cam Lock
LOCK