Post-Installation Checklist - Huawei OptiX PTN Series Quick Installation Manual

Performing the Post-installation Check

1 Post-installation Checklist

When the installation is complete, double check that these items have been properly performed.
No.
1 The cabinets are positioned in the places defined by the site-specific engineering design.
The subrack and other components are properly installed and are free of damage or
2
loose parts. No fingerprints, scratch marks, or other stains are present on the cabinets.
3 When installing the optical module, tighten the screws.
4 Cable holes at the top and bottom of the cabinets are securely sealed.
5 Cables are routed according to the engineering design.
Cables are not damaged, broken, or spliced. The cable connectors are connected
6
correctly and securely.
7 Labels at both ends of each cable and fiber are marked correctly, clearly, and neatly.
The fibers routed outside a cabinet are protected in a pipe or trough, and are protected
8
from being pulled out or pressed against by other cables or objects.
The bending radius of fibers is not less than 10 mm (G.657A2 optical fibers with short
9
strain relief boots). There are no sharp components along the routing path for the fibers.
Fibers are placed in order and are properly bound with fiber binding tape. There are no
10
sharp edges.
Fibers are properly routed without causing inconvenience to installing/uninstalling the
11
side panels of the cabinet.
Any vacant slots are covered with filler panels, and no devices are located in the air
12
intake and exhaust areas.
13 Dust filters are required for the cabinet door and the subracks.
14 Ground cables are connected to the cabinet door.
What to Check For
32
Method
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection
Visual inspection