Huawei OptiX PTN Series Quick Installation Manual page 26

6 Installing/Routing Network Cables (GE Electrical Module Scenario)
CAUTION
A TPA1EG24 or TPA2EG24 equipped with GE
electrical modules must be installed in slot 1, 16, 17 or
32 so that network cables can be routed on the side of
the chassis, without passing through a subrack cable
tray.
When a TPA1EG24 or TPA2EG24 board that has 24
FE/GE interfaces is used, network cables must be
connected to interfaces 9-20 to avoid the ejector lever
areas on both sides.
CAUTION
A TPA1EG16 equipped with GE electrical modules
must be installed in slot 1, 16, 17 or 32 so that network
cables can be routed on the side of the chassis, without
passing through a subrack cable tray.
When a TPA1EG16 board that has 24 FE/GE interfaces
is used, network cables must be connected to
interfaces 9-20 to avoid the ejector lever areas on both
sides.
CAUTION
A TPA1MPA equipped with GE electrical modules
must be installed in slot 1, 16, 17 or 32 so that
network cables can be routed on the side of the
chassis, without passing through a subrack cable
tray.
When a TPA1MPA board that has 16 FE/GE
interfaces is used, network cables must be
connected to interfaces 9-16 to avoid the ejector
lever areas on both sides.
23