To Start/Stop Operation Mode And To Set The Temperature - Daikin FTXTA30A2V1BW User Reference Manual

5 | Operation

5.3.1 To start/stop operation mode and to set the temperature

User reference guide
20
Setting
Fan
Additional info:
▪ Outside temperature. The system's cooling or heating effect decreases when the
outside temperature is too high or too low.
▪ Defrost operation. During heating operation, frost might occur on the outdoor
unit and decrease the heating capacity. In that case, the system automatically
switches to defrosting operation to remove the frost. During defrosting
operation, hot air is NOT blown from the indoor unit.
▪ Humidity sensor. Control the humidity by decreasing the humidity during cooling
process.
1 Press one or more times to select the operation mode.
Result: The mode will be set as follows:
2 Press to start operation.
Result: and the selected mode are displayed on the LCD.
3 Press or one or more times to lower or raise the temperature.
Cooling operation Heating operation Automatic
18~32°C 10~30°C
Note: When using drying or fan only mode, you cannot adjust the temperature.
4 Press to stop operation.
Result: disappears from the LCD. The operation lamp goes off.
The system only controls the airflow (airflow
rate and airflow direction).
The system does NOT control the temperature.
: Unit is operating.
: Operation mode = Automatic
: Operation mode = Drying
: Operation mode = Cooling
: Operation mode = Heating
: Operation mode = Fan only
: Shows the set temperature.
operation
18~30°C
Description
Drying or Fan only
operation
—
FTXTA30A2V1BW
Split system air conditioner
4P518786-4F – 2020.05