Lubrication; How To Change Oil; How To Change Oil Filter; Lubricate And Cooling Of Needles And Threads - Texi Treccia Operation Manual

TEXI Treccia & Treccia C Matic operation manual

2. LUBRICATION

1. Please oil with TERESSTIC T32 oil or its equivalent.
2. The lubricating oil has been drained from the machine before delivery. Remove screw (A), and fill the oil until the oil level
reaches between lines H and L of oil level gauge (Fig. 3, 4).
3. Be sure to check every day and refill the oil, if oil level is lower than line L of oil level gauge. When you begin operating the
machine, please check whether all the lubricating system is at normal condition.
* Before starting a brand-new machine or a machine which has not been used for more than a couple of week oiling
the needle bar.

3. HOW TO CHANGE OIL

1. Loosen Screw (1), drain all the oil from the tank, then fasten the screw (Fig. 5).
2. For extending life of the machine, change oil after the initial 4-week operation. After that, change oil every four months.

4. HOW TO CHANGE OIL FILTER

This machine is equipped with an oil filter, and the filter must be cleaned every mouth, replace the filter if necessary (Fig. 6).

5. LUBRICATE AND COOLING OF NEEDLES AND THREADS

Fill reservoir (1) and(2) with silicone oil to prevent the thread from breaking (Fig. 7).

6. HOW TO REPLACE THE NEEDLES

1. See specifications of the needles.
2. Loosen Screw (1), then pull out the used needles.
Insert the new needles into the holder holes as far as they can go,
and let the long groove of the needle face you (Fig. 8).
3. Fasten Screw (1).
Needle system: UY 128 GAS
3