Stopping The Unit; Power Down; Shut Down - Thermo Scientific ADVANCED Series Manual

Section 4 Operation
Stopping
the Unit

Power Down

Shut Down

CAUTION
CAUTION
CAUTION
Restarting
4-22
Ensure the stop symbol has a box around it, if not use the arrow keys to
navigate to the symbol.
Press . The unit will stop and the stop symbol will turn into a start
symbol ( ).
Stop Symbol
Press . The thermostat's screen will go blank and the blue LED
will illuminate.
Place the circuit protector on the rear of the thermostat to
the O position. The blue LED will extinguish.
On refrigerated units, place the circuit protector on the rear of
the bath to the O position.
Using any other means to shut the unit down can reduce the life
of the compressor.

Always turn the unit off and disconnect it from its supply voltage
before moving the unit.
The circuit protector(s) located on the rear of the component(s) is
not intended to act as a disconnecting means.
NOTE When quickly restarting refrigerated units, the compressor may
take up to 10 minutes before it starts to operate.
SP1
+020.00
+024.29 °C
Internal Temp..

Menu
in
I
O


Thermo Scientific