Replacing The Grass Deflector; Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro Z Master Professional 6000 Series Operator's Manual

Replacing the Grass
Deflector
WARNING
An uncovered discharge opening could allow
the lawn mower to throw objects at you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Do not operate the lawn mower unless you
install a cover plate, a mulch plate, grass
deflector or bagger.
1. Remove the locknut, the bolt, the spring, and the
spacer holding the deflector to the pivot brackets
(Figure 109).
2. Remove the damaged or worn grass deflector
(Figure 109).
Figure 109
1. Bolt
2. Spacer
3. Locknut
4. Spring
3. Place the spacer and the spring onto grass
deflector.
4. Place the J-end of the spring behind the deck
edge.
Note:
Make sure that the J-end of the spring is
installed behind the deck edge before installing
the bolt as shown in
5. Install the bolt and the nut.
6. Place the J-hook end of the spring around the
grass deflector (Figure
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the
full down position.
5. Spring installed
6. Grass deflector
7. J-hook end of spring
Figure 109.
109).

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the mower to the transport position.

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
g015594
71
-
EUTRAL LOCK