Toro Z Master Professional 6000 Series Operator's Manual page 66

1. Adjustment nut
2. Jam nut
11. For mower decks shown in
the adjustment nut on the front deck-lift
assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can utilize the single-point adjustment to gain
more adjustment.
1. Adjustment nut
2. Jam nut
Figure 97
3. Rear deck adjustment
4. Front deck adjustment
Figure 98, fine-tune
(Figure 98).
Figure 98
3. Rear deck adjustment
4. Front deck adjustment
12. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 99).
g027344
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the
single-point-adjustment bolt by rotating it
clockwise. If the deck is too high, loosen
the single-point-adjustment bolt by rotating it
counterclockwise
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
the length of the available travel in their slots.
This regains some up and down adjustment on
each of the 4 deck links.
g010251
1. Single-point adjustment bolt
66
Figure 99
(Figure 100).
Figure 100
g009176
g009042