Servicing The Fuses; Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs - Toro Z Master Professional 6000 Series Operator's Manual

Figure 65
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on the console to the right
of the seat (Figure
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse
Figure 66
1. Optional accessory (15 A)
2. Charge (25 A)
3. PTO (10 A)
3. Red (+) charger lead
4. Black (-) charger lead
66).
(Figure 66).
4. Main (25 A)
5. Console
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Visually inspect seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace before
operating if damaged.
Checking the Rollover
g000960
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure that the
knobs are fully engaged with the roll bar in the raised
position. The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to get both
knobs fully engaged
g008966
50
(Figure 67).