Toro Z Master Professional 6000 Series Operator's Manual page 35

4. Swing the stand foot out front and slide it
toward machine, into the bottom of slot
42 and Figure 43).
Figure 43
1. Z Stand (positioned in slot) 3. Latch resting on pivot tab
2. Crack in side walk or turf
5. Set the foot of the stand on the ground and rest
the latch on the pivot tab
6. Start the engine and put it at half throttle.
Note:
For best results, place the foot of the
stand into the seams in sidewalks or into the turf
(Figure 43).
7. Drive the machine onto the stand. Stop when
the latch drops over the tab into the locked
position (Figure 43).
8. Engage the parking brake and turn off the
engine.
9. Chock or block the drive wheels.
WARNING
The parking brake may not hold the
machine parked on the Z Stand and
could cause personal injury or property
damage.
Do not park on the Z Stand unless the
wheels are chocked or blocked.
10. Perform the maintenance.
(Figure
g001812
(Figure 43).
Driving off the Z Stand
1. Remove the chocks or blocks.
2. Raise the latch to the unlocked position
44).
1. Z Stand
2. Latch
3. Start the engine and place it at half throttle.
Disengage the parking brake.
4. Slowly drive backward off the stand.
5. Return the stand to its rest position
35
Figure 44
3. Locked position
4. Unlocked position
(Figure
(Figure
g001813
42).