Detachable Controller - Fostex D-108 Owner's Manual

<Detachable Controller>
8
43
PUNCH
IN / OUT
8. Controller Connection Cable
Connect this cable to the D-108 controller connection jack.
9. Meter display
This meter display shows the signal level and settings.
* Refer to the "Display section" on page "18."
10. Record Track Select key [RECORD TRACK]
Select "SAFE-READY" of the track to record. Pressing the
key once will cause the corresponding track to enter the
READY mode, and the track displayed (
Pressing the key again will cause the corresponding track
to enter the SAFE mode, and the track display to turn
OFF. When you only press the RECORD button in the
READY mode, the track that is READY will enter the input
monitor state, and the recording level can be adjusted.
Pressing the RECORD button again will put the system
back in the REPRODUCTION MONITOR state. You can
also use this key to select tracks to copy & paste, move &
paste, erase and other editing features, as well as to execute
the envelope feature.
<Note>
The panel comes with numbers for track 9-16, however, only
tracks 1-8 are operational.
* Refer to page "26" for details about the reproduction monitor
and the input monitor.
11. Shift key [SHIFT]
The connect slave unit's recording track is used in the
SAFE-READY mode if the D-108 is used as the master
system for MIDI slave synchronization.
* Refer to page "82" for details about using the SHIFT key.
10
9
8TRACK DIGITAL RECORDER
RECORD TRACK
7/15 8/16
1/9 2/10 3/11 4/12 5/13 6/14
LOCKED HD ACCESS TC IN
42
40 41
) will flash.
D-108 Owner's Manual (Names and Functions)
13
15
11
12 14 17
AUTO RTN
CLIPBOARD AUTO PUNCH
AUTO PLAY IN OUT START
D-108
COPY MOVE PASTE ERASE
AUTO
REHEARSAL
PUNCH LOCATE
TAKE
OPTICAL
ENVELOPE
RECORD STOP PLAY REWIND
SHIFT
CLIPBOARD PLAY
LOCATE ABS 0
LOCATE REC END
32 35 36 37 38
33 31 30 29
12. Auto Play/Auto Return key
Pressing this key repeatedly will change Auto Play mode,
Auto Return mode, and Repeat mode On/Off as follows:
( : LED off,
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
AUTO RTN
AUTO PLAY
Auto Play mode:
In this mode, playback will start automatically after the
START point is located. This function is effective at any
locate points other than the ABS END point.
Auto Return mode:
When the END point is reached during playback, the
START point is automatically located in this mode. This
function is effective only when the START and END points
have been specified.
<Note>
The Auto Return function is works only during playback. In the
recording mode, the START point will not be located automatically
when the END point is reached.
9
18
16 19 20
EXECUTE EXIT
IN OUT END DISP SEL /YES /NO
AUTO RTN TIME BASE SEL
UNDO REDO HOLD/ STORE RECALL
PGM SEL PREVIEW
VARI PITCH
F FWD
39 26 25
34 27
28
: LED light up)
Auto Play/Auto Return OFF
(All LEDs are off.)
Auto Play ON
(Only the AUTO PLAY LED is lit.)
Auto Return ON
(Only the AUTO RTN LED is lit.)
Auto Repeat ON
(Both AUTO PLAY and AUTO RTN
LEDs are lit.)
21
22
23
24