Auto Play; Auto Return - Fostex D-108 Owner's Manual

The Auto Play function allows the D-108 to start play back automatically from the located point.
AUTO PLAY mode should be turned on before you execute the Direct Locate function described above.
Note:
This function is effective within 24 ABS hours. Therefore, if playback continues over the recording end point, the
D-108 will still continue counting the time. Also, when the D-108 locates ABS REC END, it will continue counting the time
from the recording end point. (However, the D-108 does not access the disk after reaching the recording end point.)
<Example: Operation at locating to the AUTO PUNCH IN point.>
1. Press the AUTO RTN/AUTO PLAY key to turn on
the [AUTO PLAY] LED.
2. Press the LOCATE key, or memory key.
The D-108 locates the point and plays as shown in the
diagram.
This function allows the D-108 to play data up to the AUTO RTN END point, then automatically locate the AUTO
RTN START point as shown in the diagram below. To enable this function, AUTO RTN mode should be on and the
AUTO RTN START point and AUTO RTN END point should already be set.
<Operation of the Auto Return mode.>
1. Store the AUTO RTN START and AUTO RTN END
points.
Refer to the chapter "Storing a Locate Point (Edit Point)"
on page 54 for information on storing the desired points
in the AUTO RTN START key and the AUTO RTN END
key.
2. Press the AUTO RTN/AUTO PLAY key to turn on
the [AUTO RTN] LED.
LOCATE
LOCATE
START
AUTO RTN

AUTO PLAY

AUTO RTN START point
PLAYBACK
START
Automatic locating to the AUTO RTN START point
subsequent to playback to the AUTO RTN END point.
STOP
AUTO RTN
AUTO PLAY
D-108 Owner's Manual (Locate Function)
Auto Play
AUTO PUNCH IN point
PLAYBACK
PLAYBACK
3. Press the STOP button to stop the D-108.
• You can set a preroll time in the [Preroll Time ?] menu in
SETUP mode so that the D-108 will start playback preroll
time before the locate point.
You can set the preroll time from 0 to 10 seconds. Refer to
the chapter "Changing the Initial Settings (SETUP Mode)"
on page 111.

Auto Return

PLAYBACK
LOCATE
3. Start playback a little before the AUTO RTN END
point.
The D-108 operates as shown in the diagram.
• You can set a preroll time in the [Preroll Time ?] menu in
SETUP mode so that the D-108 will start playback preroll
time before the locate point. You can set the preroll time
from 0 to 10 seconds. Refer to the chapter "Changing the
Initial Settings (SETUP Mode)" on page 111.
61
LOCATE
LOCATE
START
AUTO RTN END point