Manual Punch In/Out Recording; Preparation; Rehearsing Manual Punch In/Out Recording - Fostex D-108 Owner's Manual

8 track digital recorder
Hide thumbs Also See for D-108:
Table of Contents

Advertisement

This section explains how to perform Manual Punch In/Out using a foot switch (optional Model 8051).
You do not need to specify the Punch In/Out points. Instead, you press the foot switch at the Punch In/Out point.
Manual Punch In/Out also offers rehearsal and actual takes. You can repeat rehearsal until you are ready.
As an example, replace a part of the recorded guitar solo on track 3.
Check to see that the guitar is connected to the input jack of the mixer, as required for [AUTO PUNCH IN/OUT]
mentioned earlier.
Connect an optional foot switch (Model 8051) to the PUNCH IN/OUT jack on the rear panel.
In Rehearsal mode, the READY track enters input monitoring mode between the Punch In and Out points (the
points at which you press the foot switch), and the sound is not recorded. You can practice the Punch In/Out
operation repeatedly before you proceed to actual recording.
1. Press the foot switch while holding down the STOP
button.
[Rehearsal On] will appear on the display dor about 1
second, then rehearsal mode will appear and the
REHEARSAL LED (green) of the AUTO PUNCH key flashes.
AUTO
PUNCH
2. Press the RECORD TRACK select key [3] to set
track 3 to READY.
3. Press the PLAY button to play back from a point
slightly before the Punch In point.
Manual Punch In/Out
• Initialize the D-108.
• Select a desired Program for Punch In/Out.
• Check a sampling frequency of the D-108.
POWER
Foot Switch Model 8051

Rehearsing Manual Punch In/Out recording

REHEARSAL
TAKE
D-108 Owner's Manual (Punch In/Out Recording)

Preparation

D-108
8TRACK DIGITAL RECORDER
RECORD TRACK
1/9
2/10
3/11
4/12
5/13
6/14
7/15
8/16
SHIFT
PUNCH
IN / OUT
LOCKED
HD ACCESS
TC IN
4. Play the guitar accompanying the playback of tracks
1 to 8.
The recording level and monitor volume is adjusted on
the mixer in the same manner as done for [AUTO PUNCH
IN/OUT] descrived earlier.
5. Press the foot switch once at the desired Punch In
point, then press the foot switch again at the desired
Punch Out point.
The rehearsal mode will operate as shown in the figure.
Between the Punch In and Out points the current
performance of the guitar will be played as the guitar
monitor sound. The previous recording is heard in any
other case. The RECORD LED lights up when Punching In
and turn off when Punching Out. (the REHEARSAL LED
remains flashing)
43
AUTO RTN
CLIPBOARD
AUTO PUNCH
EXECUTE
AUTO PLAY
IN
OUT
START
IN
OUT
END
DISP SEL
/YES
AUTO RTN
TIME BASE SEL
COPY
MOVE
PASTE
ERASE
UNDO
REDO
HOLD/
STORE
PGM SEL
AUTO
REHEARSAL
PUNCH
LOCATE
VARI PITCH
TAKE
OPTICAL
ENVELOPE
RECORD
STOP
PLAY
REWIND
F FWD
CLIPBOARD PLAY
LOCATE ABS 0
LOCATE REC END
EXIT
/NO
RECALL
PREVIEW

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents