External Midi Equipment Sync System By The Slave Mode - Fostex D-108 Owner's Manual

Execution of recording
A variety of recording work can be carried out with all three D-108's in the chase lock mode.

External MIDI equipment sync system by the slave mode

Up to this point, synchronization with external MIDI equipment has been explained with the D-108 as the master and
MIDI equipment as the slave but depending on the slave mode setting, the MIDI equipment can be set as the master and
D-108 as the slave.
<Note>
External MIDI equipment which can be used as the master is limited to those which can output MTC.
* Initialize D-108.
* Confirm the program and sampling frequency.
* In the following, the explanation will be on the assumption that a computer (with sequence software) is used.
Connection to external equipment
Connect MIDI OUT of the computer (with MIDI interface) with MIDI IN of D-108. The computer sequence software
complying to MMC/MTC must be activated.
Setup of external equipment
Sequence software is setup as follows.
* Set for output of MTC.
* Set frame rate of the MTC to be output.
* Confirm start time of the tune.
# Refer to Owners Manual of the respective equipment for details.
D-108 (Slave)
POWER
1/9 2/10
PUNCH
IN / OUT
D-108 Owner's Manual (MIDI Synchronization)
Master
COMPUTER
with MMC/MTC
software
MIDI OUT
MIDI IN
AUTO RTN
CLIPBOARD
AUTO PLAY IN
D-108
8TRACK DIGITAL RECORDER
COPY MOVE
AUTO
REHEARSAL
PUNCH
TAKE
OPTICAL
ENVELOPE
RECORD STOP
RECORD TRACK
3/11 4/12 5/13 6/14 7/15 8/16 SHIFT
LOCKED HD ACCESS TC IN CLIPBOARD PLAY
LOCATE ABS 0
LOCATE REC END
83
AUTO PUNCH EXECUTE EXIT
OUT START IN OUT END DISP SEL /YES /NO
AUTO RTN TIME BASE SEL
PASTE ERASE UNDO REDO HOLD/ STORE RECALL
PGM SEL PREVIEW
LOCATE VARI PITCH
PLAY REWIND F FWD