Table of Contents
Advertisement
14. Type 1 (Display hardware resource information details) next to the drive you want to replace. Press
Enter.
The Disk Unit Hardware Resource Information Details is displayed like the shown in the following
sample.
Disk Unit Hardware Resource Information Details
Manufacturer . . . . . . . . . . . . . . : IBM
Product ID . . . . . . . . . . . . . . . : SG9XCA2E200GEIBM
Firmware Version . . . . . . . . . . . . : 53433436 (SC46)
Serial Number. . . . . . . . . . . . . . : 50B0042M
Capacity . . . . . . . . . . . . . . . . : 177.80 GB
Physical location
PCI Address. . . . . . . . . . . . . . . : 0000:01:00.0
Resource Path. . . . . . . . . . . . . . : 00-0E-02
SCSI Host Number . . . . . . . . . . . . : 0
SCSI Channel . . . . . . . . . . . . . . : 0
SCSI Id. . . . . . . . . . . . . . . . . : 5
SCSI Lun . . . . . . . . . . . . . . . . : 0
Platform Location. . . . . . . . . . . . : U5887.001.Z065075-P1-D3
Extended Details
Press Enter to Continue
e=Exit
q=Cancel
f=PageDn
Figure 70. Example Disk Unit Hardware Resource Information Details display
15. Record the physical location information.
16. Return to the IBM Power RAID Configuration Utility display.
Rebuilding data on a replacement disk drive or solid-state drive in a
system or logical partition running Linux
You can rebuild data on the replacement drive that was replaced because of a failed disk drive or
solid-state drive or as a new installation.
If a hot-spare drive was available and protected the disk array throughout the drive failure, you can
configure the newly installed drive as a hot spare. For instructions, see the PCI-X SCSI RAID Controller
Reference Guide for Linux.
100
Disk drives or solid-state drives
b=PageUp
More...
Advertisement
Table of Contents
