Table of Contents
Advertisement
7. Carefully slide the enclosure management controller into the system and close the latch (A) as shown
in Figure 76.
Figure 76. Replacing the enclosure management controller
8. Carefully lift and align the I/O system board with the slot at the rear of the expansion unit.
9. Insert the I/O system board firmly into the server, as shown in Figure 77 on page 112.
10. Secure the I/O system board with the locking tabs (A), as shown in Figure 77 on page 112.
Related tasks for disk drives or solid-state drives
111
Advertisement
Table of Contents
