Table of Contents
Advertisement
6. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
7. When the identify LED turns on solid, slide the disk drive or solid-state drive all the way into the
system or an expansion unit, and push the drive handle (A) in until it locks, as shown in Figure 35.
Figure 35. Replacing a disk drive in the system
8. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for completing the disk drive or solid-state drive replacement by using the
diagnostic command. For instructions, see "Completing the disk drive or solid-state drive replacement by
using the diagnostic command" on page 58.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
3. Select the drive that you want to replace and press Enter on the console.
4. When the solid-state drive identify LED turns on solid, slide the solid-state drive all the way into the
EDR1 PCIe storage enclosure until it is fully seated. Then rotate the handle (A) to the locked position.
See Figure 36 on page 58.
5. On the console, press Enter to indicate that you have installed the solid-state drive.
6. Install the bezel (B).
Replacing a disk drive or solid-state drive
57
Advertisement
Table of Contents
