Table of Contents
Advertisement
Figure 52. Replacing the SAS cable
3. Replace all PCI adapters in the adapter cassettes. To install the PCI adapter cassette in the system or
expansion unit, see Installing a PCI adapter contained in a cassette.
4. Start the system or logical partition. For instructions, see "Starting the system or logical partition" on
page 139.
5. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 161.
v If you installed the part for any other reason, verify the installed part. For instructions, see
"Verifying the installed part" on page 149.
You may now attach other supported SAS features to your system.
86
Disk drives or solid-state drives
Advertisement
Table of Contents
