Table of Contents
Advertisement
`````
Figure 33 Weather Shield
Installation
Figure 34 Terminal Guard Installation
P A R T 1 0 : T E R M I N A L G U A R D I N G
Fit the weather shield and guard to the
back of the flue unit as detailed below
(see figures 33 & 34).
10.1 Remove the two screws near the
sides of the terminal end just below the
louvres. Remove the screw near the
bottom of the terminal end.
10.2 Place the weather shield in
position aligning the holes in the shield
with those at the sides of the end
plate. Secure with the two screws
previously removed. see figure 33.
10.3 Fit the terminal guard (see
figure 34). Secure the guard at the
bottom and at the top between the
two right hand columns of
louvres using screws included in
the fixings pack and the washers
which were holding the guard to
the convection box for transit (see
section 4.3) .
21
Advertisement
Table of Contents
