Table of Contents
Advertisement
Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this equipment from any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near the equip-
ment and must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting
it fall may cause damage.
7.
Make sure the voltage of the power source is correct before connecting the
equipment to the power outlet.
8.
Position the power cord so that people cannot step on it. Do not place anything
over the power cord.
9.
All cautions and warnings on the equipment should be noted.
10.
If the equipment is not used for a long time, disconnect it from the power source
to avoid damage by transient overvoltage.
11.
Never pour any liquid into an opening. This may cause fire or electrical shock.
12.
Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
13.
If one of the following situations arises, get the equipment checked by service
personnel:
The power cord or plug is damaged.
Liquid has penetrated into the equipment.
The equipment has been exposed to moisture.
The equipment does not work well, or you cannot get it to work according to
the user's manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
14.
DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE
STORAGE TEMPERATURE MAY GO BELOW -25° C (-13° F) OR ABOVE 60°
C (140° F). THIS COULD DAMAGE THE EQUIPMENT.
15.
This equipment has been tested and found to comply with the requirements for
a Class A digital device.Operation of this equipment in a residential area is likely
to cause harmful interference to radio communications; in such events, users
are required to correct this interference.
16.
This equipment is sold without a power cord. Users are advised to purchase a
CCC-certified power cord.
CAUTION: THE COMPUTER IS PROVIDED WITH A BATTERY-POWERED REAL-
TIME CLOCK CIRCUIT. THERE IS A DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT
TYPE RECOMMENDED BY THE MANUFACTURER, DISCARD USED BATTERIES
ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.
The sound pressure level at the operator's position according to IEC 704-1:1982 is
no more than 70 dB (A).
DISCLAIMER: This set of instructions is given according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of any statements contained herein.
MIC-7420 User Manual
vi
Advertisement
Table of Contents
