Sds Remote Control; Setting Sds Remote Control; Man Down; Setting Man Down - Motorola MTP830 S Feature User Manual

SDS Remote Control

SDS Remote Control is a feature that enables to remotely control behavior and configuration of the radio via special
SDS messages. The messages can be sent both in TMO and DMO (including the Repeater Mode) by any radio
capable of controlling other radios. During the execution of the Remote Control messages, depending on your service
provider settings, the radio can play a tone, vibrate, or display an appropriate icon in the status icon area.
Note: This is a selling feature.

Setting SDS Remote Control

When and where to use: To enable/disable support of special SDS messages that allow remote control of the radio.
Procedure:
1 From the home screen, press the
2 Select Security → Remote Control.
3 Select On to enable, or Off to disable remote control.

Man Down

Man Down alerts when no movement occurs for a set time or the radio stays at an angle of tilt below a defined value.
The radio alerts you when:
• its tilt exceeds a predefined angle value.
• it remains static for a predefined time.
In case any of the above conditions are met, the radio alerts you with a Man Down pre-alert. If you do not remove the
pre-alert condition, the radio switches to the Emergency Operation.
For the easier localization of the radio, visual and audible indications are started until they are deactivated. If the
Emergency Hot Microphone is on, the additional audio indication is not played.
To exit Man Down, exit the Emergency Mode by pressing and holding the ExitS
Note: This is a selling feature.

Setting Man Down

Procedure:
1 From the home screen, press the
2 Select Man Down.
3 Select one of the following:
• On — Activates the feature.
• Off — Deactivates the feature.

Setup

This sub-menu allows you to change your radio configuration.
key.
MENU
key.
MENU
Main Menu | 73
key, or press the PTT button.
OFT
| | Send Feedback