Videonics MXPro User Manual page 86

78
Chapter 7
Default Settings for Route Function
IN 1 routes to Channel A
POWER
IN 3 routes to Channel C
1 2
VIDEO
IN (Y/C)
3 4
If your set up does not match the default options, you need to change the Route set-
tings. For example, assume you have an S-Video VCR attached to the input jacks
marked 1 ( IN 1 ), and a Composite VCR attached to the input jacks marked 2 ( IN 2 ).
You don't need to change anything for the first input because it matches the default
settings. However, because the second source is a Composite device (rather than S-
Video) you need to notify MXPro of this fact.
Procedure
To reconfigure Route settings:
1 Turn on both source devices and the Preview monitor. Start the source devices
rolling.
2 Turn on MXPro.
The introduction screen appears on the Preview monitor and, after a moment or
two, the Preview screen replaces the introduction.
3
Press ROUTE to display the Route menu.
1 2 VIDEO 3
IN
IN 4 routes to Channel D
Videonics MX-Pro User Guide
IN 2 routes to Channel B
L
2
1
AUDIO
4
IN
R
L
4 DI
3
R