Live Broadcast Configuration - Videonics MXPro User Manual

26
Chapter 3
Live Broadcast Configuration
This configuration is useful in a live broadcast environment.
1
Connect the VIDEO OUT from Camera 1 to VIDEO IN 1 on the MXPro rear panel.
Connect the AUDIO OUTs from Camera 1 to AUDIO IN 1 on the rear panel.
2 Connect the VIDEO OUT from Camera 2 to VIDEO IN 2 on the MXPro rear panel.
Connect the AUDIO OUTs from Camera 2 to AUDIO IN 2 on the rear panel.
3
OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to
AUDIO IN 4 on the MXPro rear panel.
4
Connect a Composite-type monitor to the PREVIEW OUT jack on the rear panel.
5
OPTIONAL – Connect a GPI trigger device to the GPI CONTROL on the MXPro
rear panel.
6 OPTIONAL – Connect a Character Generator (CG) to the OUT Y/C jack on the
rear panel.
With this configuration you can superimpose titles from the CG atop the output
signal.
7
Connect a recording VTR to the OUT Y/C jack on the rear panel.
If you are using the optional Character Generator (described above), connect the
output from the CG to the VTR input.
8
Connect an Output Monitor to the recording VTR so you can see the signal being
recorded.
9
Connect the Power Cord and Transformer to the MXPro rear panel. See "Power
Connector" on page 22 for instructions.
Use the Route function (see page 77) to make sure your devices are directed to the cor-
rect MXPro channels.
Videonics MX-Pro User Guide