Post Production Configuration - Videonics MXPro User Manual

28
Chapter 3
Post Production Configuration
This configuration is useful in a Post-Production environment where you mix two or
more programs together.
1 Connect the VIDEO OUT from VTR 1 to VIDEO IN 1 on the MXPro rear panel.
Connect the AUDIO OUTs from VTR 1 to AUDIO IN 1 on the rear panel.
2
Connect the VIDEO OUT from VTR 2 to VIDEO IN 2 on the MXPro rear panel.
Connect the AUDIO OUTs from VYR 2 to AUDIO IN 2 on the rear panel.
3
OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to
AUDIO IN 4 on the MXPro rear panel.
4
Connect a Composite-type monitor to the PREVIEW OUT jack on the rear panel.
5 OPTIONAL – Connect a Character Generator (CG) to the OUT Y/C jack on the
rear panel.
With this configuration you can superimpose titles from the CG atop the output
signal.
6
Connect a recording VTR to the OUT Y/C jack on the rear panel.
If you are using the option Character Generator (described above), connect the
output from the CG to the VTR input.
7 Connect an Output Monitor to the recording VTR so you can see the signal being
recorded.
8
Connect the Power Cord and Transformer to the MXPro rear panel. See "Power
Connector" on page 22 for instructions.
Use the Route function (see page 77) to make sure your devices are directed to the cor-
rect MXPro channels.
Videonics MX-Pro User Guide