Primary Settings - ABB AC-AP Series User Manual

Sub-menu Function
Show in lists Show or hide the numeric IDs of:
• parameters and groups
• option list items
• bits
• devices in Options
Pass code Enter pass codes into this parameter to activate further access levels (for
example additional parameters).

Primary settings

The Primary settings menu has the following sub-menus.
Note: The contents displayed may vary based on the drive/device to which the panel
is connected. The menu shown is only an example.
Sub-menu
Macro
Drive
Motor
Loop controller
Pump and fan
control
Communication
Start, stop,
reference
Ramps
Limits
→
Function
Set up drive control and reference source by selecting from a set of
predefined wiring configurations.
Adjust drive related settings, such as control location, run permissions,
ramps, limits, constants speeds, flying starts references.
Adjust motor-related settings, such as control mode, nominal values, ID
run or thermal protection. Note that the settings that are visible depend
on other selections, for example vector or scalar control mode, used
motor type or selected start mode.
Set up loop controller settings and actual values. Loop controller is only
used in remote control.
Controls one motor connected to the drive and up to 3 auxiliary motors.
Use the drive with a fieldbus.
Set up start/stop commands, reference, and related features, such as
constant speeds or run permissions.
Set up acceleration and deceleration settings.
Set the allowed operating range. This function is intended to protect the
motor, connected hardware and mechanics. The drive stays within
these limits, no matter what reference value it gets.
Functions in the main Menu 45
Select drive.