Home View; Navigating In The Home View - ABB AC-AP Series User Manual

Home view

The main view of the control panel is called the Home view. In the Home view, you
can monitor the status of the drive, such as its speed, torque or power. The Home
view has one or more pages, each of which can display up to three signals.
The number of pages and the signals shown on each page are customizable, and the
Home view configuration is saved to the drive whenever you change it. The maximum
total number of signals displayed varies from 9 to 21, depending on the drive. In the
example below, three Home view pages are used, showing different display formats.
Each application macro and user set has a default Home view configuration. When
you select an application macro or restore a user set, the Home view configuration
changes accordingly. There is a default Home view configuration in each drive, which
can be restored in the
Note: The Menu varies based on the drive/device to which the panel is connected.
The Home view opens automatically when you power up the drive. The Home view is
also displayed from the Options menu or the main Menu if no key is pressed for
10 minutes.
Tip: You can return to the Home view from any view except special screens by
holding down the left softkey


Navigating in the Home view

• Use and
page numbers are shown while you scroll between pages.
• Use or
Setting the reference
• Press
on page 31).
• Press
Options menu
Primary settings
.
to move between the different pages of the Home view. The
to adjust the reference (visible in the top right corner). See also
(page 27).
(Menu) to open the main Menu (see
( )
Options to open the Options menu (see
on page 27).
(page 45) or Settings
Functions in the main Menu
Basic operation 27
(page 44) menu.
Functions in the