User Level - Siemens RWF55.5 User Manual

Changing the
setpoints
*
*
SP1
*
*
SP2
*
*
*
*
*
dSP
*
*
*
*
*
Timeout

Building Technologies Division
Infrastructure & Cities Sector

6.3 User level

This level is started from the basic display.
Setpoints SP1, SP2 or dSP can be altered.
The values of the analog inputs InP1, InP2, InP3 and SPE (external setpoint) and InP3
(actual angular positioning between 0...100%) can be displayed.
Changing SP1, SP2 or dSP.
From the basic display, press
so that SP1 appears
Press
and SP1 flashes
Press
Press or to adjust the required setpoint and press
SP2 only appears if setpoint changeover is set (binary input bin1 = 1).
From the basic display, press
so that SP1 appears
Press
Press
to change over to SP2
and SP2 flashes
Press
Press or to adjust the required setpoint and press
dSP only appears if setpoint shifting is set (binary input bin1 = 2).
From the basic display, press
so that SP1 appears
Press
Press
to change over to dSP
and dSP flashes
Press
Press or to adjust the required setpoint and press
Timeout after about 180 seconds.
Note!
If the setpoint is not stored, the basic display changes after the timeout
former setpoint is maintained.
The value changes only within the permitted range.
User Manual RWF55...
6 Operation
so that OPr appears
so that OPr appears
so that OPr appears
to confirm
to confirm
to confirm
tout
and the
41/93
CC1U7867en
05.11.2013