Front-Panel Module - Tektronix TDS2022C Technical Reference

Front-Panel Module

TDS2000C Series Oscilloscope Service Manual
You will need a torque-limiting Torx T-15 screwdriver and a flat-blade screwdriver
for this procedure.
Refer to the exploded view diagram for the 2-channel models or the 4-channel
models. (See page 8-4.) (See page 8-6.)
Removal.
1. Remove the power button and rear case. (See page 8-10.)
2. Remove the internal assembly from the front case. (See page 6-13, Internal
Assembly.)
3. Disconnect the front-panel cable from J1 on the Front-Panel module.
4. Remove the five screws attaching the Front-Panel module to the internal
assembly.
5. Pull the module away from the internal assembly.
Installation.
1. Connect the front-panel cable to J1 on the Front-Panel module by pushing the
cable straight down into the connector.
2. Install the five screws to attach the Front-Panel module to the internal
assembly.
3. Assemble the oscilloscope by performing the installation procedure for each
module that was removed.
Maintenance
6–21