Table of Contents
Advertisement
SECTION 3 TORCH:
INSTALLATION
3T.01 Torch Connections
If necessary, connect the torch to the Power Supply.
Connect only the ESAB model SL100 / Manual or SL100
/ Mechanical Torch to this power supply. Maximum torch
leads length is 100 feet / 30.5 m, including extensions.
WARNING
Disconnect primary power at the
source before connecting the torch.
1. Align the ATC male connector (on the torch lead)
with the female receptacle. Push the male con-
nector into the female receptacle. The connec-
tors should push together with a small amount
of pressure.
2. Secure the connection by turning the locking nut
clockwise until it clicks. DO NOT use the locking
nut to pull the connection together. Do not use
tools to secure the connection.
Art # A-07885
Connecting the Torch to the Power Supply
3. The system is ready for operation.
Check Air Quality
To test the quality of air:
1.
/
Put the ON / OFF switch in the ON (up)
position.
2. Put the Function Control switch in the SET posi-
tion.
300X5397
3. Place a welding filter lens in front of the torch and
turn on the air. Do not start an arc!
Any oil or moisture in the air will be visible on the lens.
3T.02 Setting Up Mechanical Torch
The mechanical torch includes a positioning tube with
rack and pinch block assembly.
1. Mount the torch assembly on the cutting table.
2. To obtain a clean vertical cut, use a square to
align the torch perpendicular to the surface of
the workpiece.
2
1
Workpiece
3. The proper torch parts (shield cup, tip, start car-
tridge, and electrode) must be installed for the
type of operation. Refer to Section 4T.07, Torch
Parts Selection for details.
INSTALLATION
ESAB CUTMASTER 100
NOTE!
An adapter is required to be installed
in the power supply if converting
a hand torch system to operate a
machine torch.
WARNING
Disconnect primary power at the
source before connecting the torch.
Pinch Block
Assembly
Mechanical Torch Set - Up
Square
A-02585
3T-1
Advertisement
Table of Contents
